| Customization: | Available |
|---|---|
| After-sales Service: | Available |
| Warranty: | The Using Life Should Be 50 Years. |
|
Still deciding? Get samples of US$ 10/Meter
Request Sample
|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
MPP pipe, which is short for Modified Polypropylene, is a new type of composite pipe made of modified polypropylene.It is made of special formula and processing technology. It has the advantages of higher strength, better high temperature resistance, easier to install and lower cost than the general PE pipe . It is suitable for the depth of 2-18 meters.
Mpp power pipe is suitable for more than 10KV high voltage transmission wire and cable pipe, plastic pipe. It is also widely used in the area of Telecommunication pipe, Gas pipe, Water supply pipe and Heating pipe.
The implementation standard is DL/T802.7-2010.
Transportation: no scratches, throwing, violent impact, oil and chemical pollution.
| MPP Cable Conduit Pipe's Parameter Datas | ||||
| Norminal Lenght (mm),Ring Stiffness (3%) Grade (Normal Temperature) | ||||
| Nominal diameter (mm) | Norminal Wall Thickness (mm) | |||
| SN24 | SN32 | SN40 | ||
| 100 | 6 | 8 | 10 | |
| 125 | 8 | 10 | 12 | |
| 150 | 10 | 12 | 14 | |
| 175 | 12 | 14 | 16 | |
| 200 | 14 | 16 | 18 | |
| 225 | 16 | 18 | 20 | |
| 250 | 18 | 20 | 22 | |
Note:
1. This series of pipes are mainly used in MPP electric power pipe. The nominal pressure refers to the maximum allowable working pressure of the pipe conveying water at 20ºC.
2. The weight of the above table is calculated according to the average density of 0.95g/cm³, and the outer diameter and wall thickness are taken as the nominal value plus half of the limit deviation.
We have passed ISO9001:2015 quality management system certification, ISO14001:2015 environmental management system certification, ISO45001:2018 Occupational health and safety management system certification. In addition, we qualify the member cooperation unit with the State Grid Corporation of China and signed a long-term supply contract with the State Grid of China.
1. MPP pipe has excellent electrical insulation.
2. MPP pipe has higher thermal deformation temperature and low temperature impact performance.
3. MPP pipe has higher tensile and compression resistance than HDPE.
4. MPP pipe is light, smooth, frictional resistance is small, can be hot-melt butt joint.
5. MPP tube long-term use temperature-5 ~ 70 ºC.
6. Construction instructions:
1) It is strictly forbidden to drop, hit, scratch, or expose to the sun during the transportation and construction of pipes.
2) The axis of the two pipes must be aligned during the hot-melt butt joint, and the end face cutting should be vertical and flat.
3) The processing temperature, time, pressure, and climate conditions are adjusted accordingly.
4) The minimum bending radius of the pipe should be ≥75 pipe outer diameter.
){kind=link}